Sign in | Join Now | Sitemap Inquiry Basket(0)
logo
Home > News
Quick Connect Coupling

Hydraulic Check Valve

Pneumatic Couplings

Air Quick Coupling

Tell You How To use quick couplings and pneumatic fittings [2011-03-07]

Using the quick couplings is to pay for attention to some problems. For example, when installing the Pneumatic Couplingis required to pay attention to the following aspects:

In a thread using a quick couplings thread Department thickness of raw product using the appropriate winding.Tighten using the appropriate power of quick coupling, force may twist a bad connector, power connector not cause leakage and release.Will be accustomed to insert the tube best minimize flat vertical pipe cutter, pipe wall to be inserted to smooth, clean, no scratches, if any scratches, there are scratches in the pipe should be vertical minimize away.

Will minimize the best tube insertion quick couplings, plug in the end force.To test tube connected firmly, pull the power look using the appropriate tubes, pipes can not pull.Placed in the quick couplings chuck Department clasp, to prevent using the process tube was accidentally pulled out. Chuck fast connection to the outside gently pull so that there is a gap in between the two, insert the card in the gap in between the rings.

What is demolition using quick coupling step it, please note the following:First check the water inlet is closed, and guarantee the water pressure is zero; followed through the quick clasp removed; the last hand using the index finger and thumb to hold the chuck to the quick joints, even though the other hand can pull out the tube.

Here would be the environmental needs to utilize pneumatic fittings.

Pneumatic fittings system is composed of various pneumatic fittings, their utilization of the atmosphere should be: Do not use quick couplings corrosive gases, chemicals, water, steam, water and environment. Do not place accustomed to have explosive gas. Do not have vibration and shock for any place or pneumatic fittings needed to comply using the sample vibration and shock. Do not use close to heat, thermal radiation effects of the occasion, or to take appropriate measures. Place with direct sunlight, protection measures should be added. A decrease of water, essential oil or welding flowers occasions, shall take the necessary protective measures. In the humidity, dust and extra occasions, shall take the necessary protective measures.

Pneumatic fittings and choice of designers who made pneumatic system quick couplings should be based on performance requirements, look at the safety and possible failure, according to the newest product or service examples and information to determine the specifications of pneumatic fittings. Necessary to complete the appropriate analysis and testing. Recommendations and following consultation pneumatic manufacturer selection, and also emergency minimize off circuit, press the clutch and brake using the circuit, safety machines and also the like, on the individual and property should have a substantial influence on the request in consultation using the producers of pneumatic fittings following Selection.

Broadly speaking, pneumatic fittings tools is to utilize compressed quick couplings oxygen driven pneumatic fittings engine and also the kinetic energy of external perform output of a tool, in accordance with its basic perform can be divided into: Rotary eccentric movable vane. Reciprocating piston volume.General pneumatic device elements mainly by power output, operating some type of conversion, intake and exhaust path area to available and stop the operation control part, device circumstance and so the principle part, of course, the operation of pneumatic tools must be also part of the energy supply, oxygen filters and oxygen pressure conditioning components and device accessories.

Pneumatic fittings series consists of: oxygen pressure producing device,the pneumatic fittings oxygen compressor. Pneumatic actuators. Pneumatic control components accustomed to control the working fluid pressure, flow and flow way with the implementation of the necessary components to total the movement qualities of components, such as pressure, flow and directional control valves and various logic devices, etc.. Sensors and conversion devices will be charged into a pressure parameter detected and also the signal of Qigong and also the gas sensor signal and also the electro-hydraulic components such as signal conversion with each other. Pneumatic accessories, which includes thoroughly clean oxygen source, element lubrication, element connections and components such as silencers.